Five Peugeot Keys Lessons From The Pros
Peugeot 208 Key Replacement
Peugeot 208 key replacement should be left to professional auto locksmiths who have the right equipment and technical know-how. They will be able to create and program new keys quicker than a dealership and at a cheaper cost.
A dead battery for your coin is most likely to blame the reason your key-fob stops locking or unlocking doors. There are also other reasons for the key to be malfunctioning.
Dead Coin Battery
A dead coin battery will stop your Peugeot 208 from locking and unlocking, as well as stopping it from starting the engine. In this scenario, you will need to employ the alternate method of starting that is described in the owner's manual.
Another reason why your 208 might not be starting is that the spark plugs are been damaged. Spark plugs are what ignite the fuel to start the engine. peugeot 107 key replacement G28 have a limited life span. If they are not used enough they will eventually fail.
There is a straightforward solution to this problem. Examine the voltage of your battery with a multimeter. If it is below 11.5 volts and you are not satisfied, then it is time to replace it. It is also essential to clean the battery's contacts if it has corrosion. This can be done by lifting the rubber covers that cover the two battery terminals and using a wire brush to remove any corroded parts of the battery. Then, you should reconnect the positive pole cables to the negative.
Water Damage
If your 208 doesn't start and the battery has not been replaced, you must look at the spark plugs. It could be that they are overly filthy, making them unable to spark. This can be fixed easily by cleaning the spark plugs in the workshop.
Peugeot automobiles are equipped with a transponder that is compatible with the immobiliser. This ensures that only the right key is able to start the engine. If the chip in the Peugeot key is damaged then it won't send the correct signal to the vehicle.
Water damage is a typical cause of this issue. This is a typical issue in more cold climates where the car is exposed to rain or snow. If this is the case, you should call a reputable auto locksmith who will have all of the tools and equipment needed to modify the new key. They'll also have the latest technology and equipment needed to create the Peugeot smart key. The process should take no more than 15 minutes.
Contacts to the battery are not working properly.
Peugeot replaced the old transponder chips with a new model that is based on electronic components that are mounted on a circuitboard. The new system is effective when it's fresh, however, over time, the circuit boards start to wear out and stop functioning correctly.
This can prevent the immobiliser chip activating and causing your car to not start. If this happens, it's a good idea contact a Peugeot specialist or locksmith.
A common problem is when the battery inside the key fob starts to fail. This causes the blade of the key to stop feeding into the lock. A locksmith in your car can replace the battery and cut a new blade for you, it's typically a quick fix.
Faulty Receiver Module
If your Peugeot key fob was not working after dropping it on the floor, being exposed to a sudden rain or accidentally washing it or washing it, it could be due to a malfunctioning receiver module. The receiver is responsible for sending radio frequency signals to the on-board computer, which is responsible for controlling the centralized locking system of your Peugeot vehicle.
The key fob itself has rubber seals that block water from reaching the chip inside. However, prolonged exposure to water may penetrate these seals and damage the chip. Submerging the key fob into sea water at the beach or throwing it into the water can be especially damaging because of the high salt content.
The module will need to be replaced if your Peugeot spare key does not work anymore. This is only done by an Peugeot specialist or expert auto locksmith. In contrast to other vehicles, Peugeot keys are protected by a unique immobilizer system that requires the right coding to begin the engine. This is why it is imperative that you should only trust the Peugeot locksmith to design and program the replacement.
Computers with faulty on-board computers
The on-board computer in your Peugeot is responsible for many of the functions in your car including power windows and airbags. When something goes wrong with these systems, they will usually display a code indicating the problem. This code is stored inside the system and will stay there until the problem is resolved. This can often mean that the on-board computers to be replaced.
The most common reason for the airbag warning light to turn on is corrosion or loose connections within the sensor. This could be due to wear and tear, ageing or exposure to moisture and salt. It is imperative to have this issue resolved as soon as you can, since an airbag that is not functioning properly could be dangerous in the event of an accident.
If you encounter a card not found error on your Peugeot, the key battery inside the key fob could be weak or dead. This could prevent the key fob from sending a signal to disable the immobilizer on your vehicle's standard. You can test this by pressing the unlock button on the key fob and then trying to start your car. If this does not work, the key battery needs to be replaced.